Audits, Credentials & Certifications
Manufactured strictly to international engineering standards with certified ISO 9001:2015 QA systems, European CE PED Module H compliance, British WRAS potable water approval, and American AWWA compliance.
Verified Quality & Safety Accreditations
Every Baoming valve is engineered, poured, machined, coated, and hydrostatically tested to comply with international municipal and pressure equipment directives.
ISO 9001:2015
Quality Management SystemsComprehensive factory-wide quality audit covering raw iron ingot intake, chemical spectrum analysis, dimensional tolerance CNC verification, pressure test recording, and barcode batch dispatch tracking.
- Annual independent third-party surveillance audit
- 100% heat number metallurgical traceability
CE PED 2014/68/EU Module H
Pressure Equipment DirectiveConformity assessment Module H (Full Quality Assurance) authorizes Baoming Valve to apply CE marking across Category I, II, III, and IV pressurized industrial valves for safe deployment in European infrastructure.
- Approved for Group 1 & Group 2 fluid media
- Design pressure rating up to PN25 / Class 300
WRAS Material Approval
Water Regulations Advisory SchemeIndependent British laboratory toxicology and leaching certification confirming all non-metallic wetted components (AkzoNobel Resicoat FBE epoxy & EPDM rubber seals) impart no odor, taste, or toxicity to drinking water.
- Complies with BS 6920 suitability for potable water
- Zero microbial growth support certification
AWWA C509 / C515
American Water Works AssociationFull dimensional and test conformance for Resilient-Seated Gate Valves for Water Supply Service. Features bubble-tight shutoff at 250 psi working pressure, smooth waterway bottom, and encapsulated EPDM wedge.
- ASME B16.1 / B16.42 Class 125/150 bolt pattern
- Non-rising stem (NRS) with 2" square operating nut
TS Special Equipment License
State Class-A Pressure PipingNational government authorization for the manufacturing of Class A pressure piping valves, guaranteeing uncompromised metallurgical and safety standards across chemical, municipal, and energy transport systems.
- Periodic random surveillance sampling
- Strict nondestructive testing (NDT) compliance
EN 10204 Type 3.1 MTC
Inspection Certificate TraceabilityEvery commercial shipment is accompanied by Mill Test Certificates signed by our QA Director, certifying chemical composition (C, Si, Mn, P, S, Mg), tensile strength, elongation, and hydrostatic test log values.
- Permanent body heat numbers stamped on castings
- Independent third-party inspection (SGS/BV/TÜV) ready
Require Official Certificate Dossiers or Third-Party Inspection?
We regularly host witness testing for SGS, Bureau Veritas, TÜV, and client-appointed engineering representatives at our Quanzhou testing laboratory.